Support

Successfully Setting Up Your enduraCUT™2

The software installation is often the most time-consuming part of setting up new equipment. Instead of breaking your momentum later, it may be best to begin your software download first....

Our Best Way to Use HotFoil with CMYK Printers

Replacing a Pinch Roller on R-Series Cutters

Replacing a pinch roller on R-Series vinyl cutters is a fairly simple process. The following instructions include pictures and video. You'll need a screwdriver as you access the back of the...

Instructions for Setting Up Your EnduraLAM 3 Cold Laminator

Watch start-to-finish instructions on how to setup a new EnduraLAM 3 Laminator.

Cutting Your First Job with VE LXi and an R-Series Cutter

Watch start-to-finish instructions on How to Cut your First Job with VE LXi (and an R-Series cutter). These instructions apply after users have downloaded and installed the software and have...

Helpful 24 Inch Printer Maintenance Videos

Use these videos along with your user manual instructions found in the user manual to keep your cutters in peak performance. These videos do not replace the instructions in your cutter manuals,...

Skillfully Use the EnduraLam3 150 Cold Laminator

Watch start-to-finish instructions on how to laminate your first job with the enduraLAM-150/enduraLAM3.

Troubleshooting Basic Vinyl Tracking Problems

A major reason for poor tracking is improper alignment of sign vinyl. Long runs will be impossible to accomplish without learning to load and align vinyl properly. Notice that there...

Cannot Open Port

“What we’ve got here is failure to communicate.” In the 1967 movie classic “Cool Hand Luke,” these words were accompanied by a harsh whipping from the prison Captain. The “Cannot...