MUSE SERVO Vinyl Cutter Basic Setup Video
MUSE Servo Basic Setup Video Tutorials. This video tutorial walks you through setup and installation of the MUSE Servo Vinyl cutters, available exclusively from SIGNWarehouse.
Support
Whether you're looking for recommendations, how-to guides, or ways to improve your printing experience, we’ve got you covered with expert insights and practical solutions.
-
Answers to Your Contour Cutting Questions
What is Contour Cutting? Imagine printing a picture or drawing on a piece of paper and then cutting it out using a pair of scissors. A rushed job will probably...
-
Helpful 24 Inch Printer Maintenance Videos
Use these videos along with your user manual instructions found in the user manual to keep your cutters in peak performance. These videos do not replace the instructions in your cutter manuals,...
-
LXI Rhinestone Wizard Tutorial - Heat Press
This three-part heat press tutorial addresses how to create and apply hot fix rhinestone patterns on apparel using the LXI Rhinestone Wizard plug-in.
-
LXi Rhinestone Wizard Patterns Tutorial - Design
This three-part tutorial addresses how to create and apply hot fix rhinestone patterns on apparel using the LXI Rhinestone Wizard plug-in.
-
LXi Rhinestone Wizard Tutorial - Cutting and Weeding
This three-part LXi Rhinestone Wizard tutorial addresses how to create and apply hot fix rhinestone patterns on apparel using the LXI Rhinestone Wizard plug-in. Part 1: Design Part 2: Cutting...
-
Waste Less Vinyl by Minimizing Page Margins
Every cost-conscious operator wants to fit as many designs as possible onto as little vinyl as necessary. So when sending multiple copies of a design to the printer or cutter,...
-
Proxy Settings Error During LXi Cloud Installation
Users who receive a "proxy settings" message when trying to install the LXi Cloud program may need to adjust certain computer settings. Go to the Control Panel in Windows and...
-
Skillfully Use the EnduraLam3 150 Cold Laminator
Watch start-to-finish instructions on how to laminate your first job with the enduraLAM-150/enduraLAM3.
-
Output Size Compensation for Contour Cutting
If the contour cut is off from the printed image, you should first perform the Sensor Position Adjustment on the cutter. If the cut continues to be inaccurate you may...
-
When the Q-Series Condition Changes Automatically
Operators of Q-Series cutters may find that, when receiving a job, the machine will override the programmed condition and return to default condition settings. To avoid this, users can change...
SHOP POPULAR BRANDS
